Support Forum

[Frage] Mesh

Schlagworte:
  • Mesh overlap
jdani
jdani
22.03.2016 - 16:50 Uhr

Hello,

I have an example of mesh reinforcement (see the image). There are diferent overlaps in vertical direction betwen meshes. When I use the tool : Span reinforcement there I can define overlap in both directions(vert. and trans.), but those overlaps are fixed, the dimensions don't change. I would like to know if it is possible to define mesh where Allplan calculates overlaps by itself or I need FEM results, which I think was used in my case.

Thank you for your answer.

Danijel

Anhänge (1)

img
overlap.PNG
Typ: image/png
371-mal heruntergeladen
Größe: 63,11 KiB
Judy_AllplanFR
Judy_Allpl…
14.04.2016 - 14:53 Uhr

Hi Jdani,

In fact there is no automatic calculation of overlap in Allplan.

By looking on the 'cross section' catalog, you can see the minimum overlap for each kind of Meshes.

Than when you place any mesh, you will see the same value.

By the way, you can click on the icone 'Overlap' in longitudinal or cross direction to change it. Depending of your placement, Allplan will try to optimise the placement that the overlap is bigger than the minimum.

But there is no more possibility.

Thank you for your understanding.

Mr Judy GURAVADU
Responsable Technique Préfabrication & Ingénierie
Precast Sales & Support

Allplan France & Allplan Software Engineering

Depuis 2006