Forum de la communauté Allplan

[Question] Permanently DWG to Allplan import [Résolu]


Hello i'm new on forum

I usually use the same layers in AutoCad. In most drawings, they are reproducible.

I need to import, for example, a title block or something to Allplan.

When importing everything is nicely divided into traces (paper), but always new ones are created in the Extern 1 group.

I would like them to be imported into permanent assignment. I do not want them to create a new one for each import.

Is it possible?

Show solution Hide solution

i am not really shure if i understand your problem, but i think there is a solution.

if you want, you can map external Layer Names 8 from the AutoCad DGW) always to the same Allplan Layer. This can also be stored to an configuration file :

see online help
http://help.allplan.com/Allplan/2018-0/1033/Allplan/index.htm#4436.htm
or
http://help.allplan.com/Allplan/2018-0/1033/Allplan/index.htm#6113.htm

Allplan Webentwicklung

Private messages must be private. No support request via Private message.

i am not really shure if i understand your problem, but i think there is a solution.

if you want, you can map external Layer Names 8 from the AutoCad DGW) always to the same Allplan Layer. This can also be stored to an configuration file :

see online help
http://help.allplan.com/Allplan/2018-0/1033/Allplan/index.htm#4436.htm
or
http://help.allplan.com/Allplan/2018-0/1033/Allplan/index.htm#6113.htm

Allplan Webentwicklung

Private messages must be private. No support request via Private message.


https://connect.allplan.com/ utilise des cookies  -  Plus d'informations

Accepter