Support Forum

[Question] Bended Rebar shown as a single line [Solved]

Tags:
  • Allplan 2018-1-0
  • Engineering
  • Bar Reinforcement
  • Bended bar
  • Error Display
danus_wicaksono2014
danus_wica…
25.03.2019 - 03:36 *

Hi,

Actually, I have solved the error display for bended bar (ties/stirrups) by change some values in the Bar Mark properties tab.
But I'm still wondering, What's causing bended bars shown as a single line?
So, we can prepare and avoid the error at the first time.

D.W.Wicaksono

Attachments (3)

img
bar disp2.JPG
Type: image/jpeg
Downloaded 50 times
Size: 280,33 KiB
img
bar disp3.JPG
Type: image/jpeg
Downloaded 40 times
Size: 172,70 KiB
img
changes4.JPG
Type: image/jpeg
Downloaded 41 times
Size: 33,16 KiB

Show solution Hide solution

Judy_AllplanFR
Judy_Allpl…
25.03.2019 - 21:39 *

Hello,

There is sometime a display error when Allplan can't calculate the rounding of the nod in 3D. If i remember, this is belong to the bending pin diameter. If you edit it, than it's working better.

Maybe this can help.

Mr Judy GURAVADU
Responsable Technique Préfabrication & Ingénierie
Precast Sales & Support

Allplan France & Allplan Software Engineering

Depuis 2006

Judy_AllplanFR
Judy_Allpl…
25.03.2019 - 21:39 * [Solution]

Hello,

There is sometime a display error when Allplan can't calculate the rounding of the nod in 3D. If i remember, this is belong to the bending pin diameter. If you edit it, than it's working better.

Maybe this can help.

Mr Judy GURAVADU
Responsable Technique Préfabrication & Ingénierie
Precast Sales & Support

Allplan France & Allplan Software Engineering

Depuis 2006

danus_wicaksono2014
danus_wica…
26.03.2019 - 02:26

Hi judy,

You're right it's all about bending pin. As long as I remember it always happen when the bending factor is too small (in previous version of Allplan). So, it should be OK if I change it to a bigger value for bending factor (6).

Thank you

D.W.Wicaksono