Hi, does anyone know how to make a beam smartpart where it is possible to move points 1 and 2 in x,y,z?
Point1 = Insertation Point / Local origin of SmartPart
Place Handle at Point2
Calc rotation anlges in 2D and 3D
Add rotations with calced angles
Create BOX
Point1 = Insertation Point / Local origin of SmartPart
Place Handle at Point2
Calc rotation anlges in 2D and 3D
Add rotations with calced angles
Create BOX
Place Handle at Point2
Calc rotation anlges in 2D and 3D
Add rotations with calced angles
Create BOX
No, because the moving of this handle (at insertation point) has to move the whole SmartPart.
This logic is not implemented in SmartPart! Therefore you need a special kind of handle...
This logic is not implemented in SmartPart! Therefore you need a special kind of handle...
Of course you can add a second point as handle, and calculate the angles between these 2 points.
But before the construction you would have to pack the coordinates of this point as offset displacement into a TRANS command.
The instertation point stays somewhere in the space. In order for the SmartPart selection to work, you still need to check the "Automatic calculation of bounding box".
The instertation point stays somewhere in the space. In order for the SmartPart selection to work, you still need to check the "Automatic calculation of bounding box".
Don't worry, you can do it!
Look at the modified SmartPart Beams2.smt.
It has 2 Points :-)
Ha 2 punti :-)
It has 2 Points :-)
