Support Forum

[Frage] Incorrect bar shape in section (Reinforcement views)

Schlagworte:
  • Allplan
  • Reinforcement
  • Views
  • Section
bianchiniadam
bianchinia…
27.10.2023 - 13:25 Uhr

Hello everyone,

The attached image shows a detail of the reinforcement of a precast concrete beam.
Unfortunately the inclined bar is not properly represented in the section. The section was created with the "Reinforcement views" function.
As you can see the inclined bar is out of the beam in the section.

Is there any solution to represent the bar properly?

Thank you in advance!

Anhänge (1)

img
inclined_bar_section.PNG
Typ: image/png
86-mal heruntergeladen
Größe: 22,04 KiB

Hilfreichste Antwort anzeigen Hilfreichste Antwort verbergen

Judy_AllplanFR
Judy_Allpl…
11.01.2024 - 00:29 Uhr *

Hi,

We have seen this issue sometimes coming in some direction which are not perpendicular to the bars or when there is different angle other than 90°.

We find some trick. For example if your design again the bars with the correct dimension, the bars in the left view will be correct at first.
If you do any change like stretch a segment, than the issue will appears. (so try to do it right first -) ).

A second possible is to redo the bars just by using the tool "convert and match a bars", than you click on your wrong bars to bring the geometry and the new will be corrected.

Bye

Mr Judy GURAVADU
Responsable Technique Préfabrication & Ingénierie
Precast Sales & Support

Allplan France & Allplan Software Engineering

Depuis 2006

Anhänge (1)

img
2024-01-11_01h29_23.jpg
Typ: image/jpeg
24-mal heruntergeladen
Größe: 45,43 KiB
Judy_AllplanFR
Judy_Allpl…
11.01.2024 - 00:29 Uhr * [Hilfreichste Antwort]

Hi,

We have seen this issue sometimes coming in some direction which are not perpendicular to the bars or when there is different angle other than 90°.

We find some trick. For example if your design again the bars with the correct dimension, the bars in the left view will be correct at first.
If you do any change like stretch a segment, than the issue will appears. (so try to do it right first -) ).

A second possible is to redo the bars just by using the tool "convert and match a bars", than you click on your wrong bars to bring the geometry and the new will be corrected.

Bye

Mr Judy GURAVADU
Responsable Technique Préfabrication & Ingénierie
Precast Sales & Support

Allplan France & Allplan Software Engineering

Depuis 2006

Anhänge (1)

img
2024-01-11_01h29_23.jpg
Typ: image/jpeg
24-mal heruntergeladen
Größe: 45,43 KiB