Hello

In France the calculation of surfaces, division of heights done it according to Figure 1
either 'division simple height with factor' height < 1.80 = 0

How to preserve this setting when I leave then I return to Allplan?

the parameters according to figure 2 are not good and are a very high risk of error in our calculations of surfaces before creating the parts we didn't attentions to fine-tune the setting of figure 1.

That is why I asked how to set permanently according to figure 1

Thank you

Administrateur forum : Allplan.leforum.eu

http://allplan.leforum.eu

Olivier1

Anhänge (2)

Typ: image/png
327-mal heruntergeladen
Größe: 53,82 KiB
Typ: image/png
321-mal heruntergeladen
Größe: 52,70 KiB