Allplan Forum: Problems with walls to roofs

FredN1

08.05.2020 - 09:25

Hello

Even after all these years, I still have a lot of problems with roofs. This time I'm trying to match the height of a wall to the underside of a roof. I'm attaching a screenshot of what happens. One side of the wall matches perfectly, but (maybe) because I choose one of the roof slopes as the upper height, the part of the wall under the other slope extends above it. I'd just divide the wall into two walls, one under each slope of the roof, but then I can't put a window in the center of the wall.
Any advice/help is appreciated!

Adjuntos (1)

Type: image/png

Descargado 53 veces

Size: 349,46 KiB

11 - 12 (12)

FredN1

08.05.2020 - 19:04

Please do not be angry or offended. I did not mean to offend you. But when you suggest that I do something that I’ve already done and described in my post, of course I want to be sure that you read my post to understand my problem. I appreciate that you’ve been making roofs for 22 years. Can you help me to make them too?

Bertrand_C

08.05.2020 - 20:57 *

It's what I do.
If you don't get what you want, maybe it's because you make a mistake somewhere and not only because I did not read again all your posts.
So:
- one file per floor.
- in the file with the upper floor and the roof, you have to put a roof plan with "Roof frame". The upper plan is the roof and the lower plan is the absolute height of the floor of the level (see first picture as example, set what you want). The walls must be set like in the second picture.

You can find information in the online help.