Foro de Soporte Allplan

[Pregunta] Dimension the floor and ceiling covering in Section [Guardado]


Hi everybody,

I would like to dimension the floor covering and the ceiling covering in the room. How can I do this?

Thanks,
György

Adjuntos (1)

Type: image/png
Descargado 42 veces
Size: 61,15 KiB

Show solution Hide solution

Ok. Try to remove the check on "udate automatically" inside the section properties. It should work.

Ingegnere Edile | 3D Artist | BIM expert

Tel: +393463266095
Skype: pasqua.enzo
Website: http://www.enzopasqua.com
LinkedIn: http://www.linkedin.com/in/enzopasqua
Instragram: http://www.instagram.com/enzopasqua3d/
PEC: enzo.pasqua (please no spam) @ (please no spam) ingpec.eu

Ciao Gyorgy. You mean horizontal quote in plan?

Ingegnere Edile | 3D Artist | BIM expert

Tel: +393463266095
Skype: pasqua.enzo
Website: http://www.enzopasqua.com
LinkedIn: http://www.linkedin.com/in/enzopasqua
Instragram: http://www.instagram.com/enzopasqua3d/
PEC: enzo.pasqua (please no spam) @ (please no spam) ingpec.eu

Hi Enzo,

I don't understand exactly what you mean, but I would like to dimension the floor covering and the ceiling covering in section with vertical dimension.

Thanks,
György

Adjuntos (1)

Type: image/png
Descargado 32 veces
Size: 33,27 KiB

Sorry Gyorgy. Now I understood. Try to use instead a point in the middle of the line the point in the angle between the wall and the slab. The snap might work there.

Ingegnere Edile | 3D Artist | BIM expert

Tel: +393463266095
Skype: pasqua.enzo
Website: http://www.enzopasqua.com
LinkedIn: http://www.linkedin.com/in/enzopasqua
Instragram: http://www.instagram.com/enzopasqua3d/
PEC: enzo.pasqua (please no spam) @ (please no spam) ingpec.eu

Hi,

unfortunately, this isn't work.

Ok. Try to remove the check on "udate automatically" inside the section properties. It should work.

Ingegnere Edile | 3D Artist | BIM expert

Tel: +393463266095
Skype: pasqua.enzo
Website: http://www.enzopasqua.com
LinkedIn: http://www.linkedin.com/in/enzopasqua
Instragram: http://www.instagram.com/enzopasqua3d/
PEC: enzo.pasqua (please no spam) @ (please no spam) ingpec.eu

Hi,

Thanks!!!!
Why should I turn off the "update automatically"?

György

Cause if you switch it the finitures become a 2d design and the snaps work. After designing your quote you switch this parameter on and you have the initial situation.

Ingegnere Edile | 3D Artist | BIM expert

Tel: +393463266095
Skype: pasqua.enzo
Website: http://www.enzopasqua.com
LinkedIn: http://www.linkedin.com/in/enzopasqua
Instragram: http://www.instagram.com/enzopasqua3d/
PEC: enzo.pasqua (please no spam) @ (please no spam) ingpec.eu


https://connect.allplan.com/ utiliza cookies  -  Aqui

Acéptalo