Using reference planes on base slabs the first opening is created correctly but the second, third etc. are not punching trough the base slab.
Balázs Schneider
NAZCA Engineering Office
- first Allplan install on Interactive Unix in 1993
- 25 years in localization of Allplan
- 25 years in technical support for Allplan
Hello,
thank you for the feedback.
This problem was fixed in Allplan 2019-1.
S pozdravom | Best regards | Mit freundlichen Grüßen
Martin Mikus
Product Manager Allplan Architecture
Hi,
As you can see above I intentionally added the Allplan 2019-1 tag to the topic, because it is happening right in that version.
Balázs Schneider
NAZCA Engineering Office
- first Allplan install on Interactive Unix in 1993
- 25 years in localization of Allplan
- 25 years in technical support for Allplan
The situation is the same when you not use the Default planes for a slab. The first opening correctly uses the custom bottom and top height settings while the second, third etc. openings use the Default planes for height settings.
Balázs Schneider
NAZCA Engineering Office
- first Allplan install on Interactive Unix in 1993
- 25 years in localization of Allplan
- 25 years in technical support for Allplan
