Support Forum

Cannot change diameter of reinforcement

rhummel
rhummel
13.06.2024 - 11:49

Hello everyone,

I have a problem with changing the diameter of the reinforcement. When I try to change it in the properties menu, it is highlighted in red and no changes are possible. I am using [software name], and I don't see any specific error messages apart from the red highlight. Could someone help me with this issue?

Thanks in advance.

Anhänge (2)

img
Schermafbeelding 2024-06-13 134655.png
Typ: image/png
22-mal heruntergeladen
Größe: 64,99 KiB
img
Schermafbeelding 2024-06-13 134605.png
Typ: image/png
20-mal heruntergeladen
Größe: 60,59 KiB
SOEN
SOEN
13.06.2024 - 12:42

Dear,

Looking at the pictures it might have to do with the fact that you haven't selected a cross section catalog yet. The available diameters and their material properties (for quantity calculations) are stored in these catalogs. By default Allplan should have installed some catalogs already. If not, a reinstall might be necessary (and check all the extras that can be installed in the install menu, at the top where you also fill in your central folder path etc.).

Kind regards,

Nick