Support Forum

[Frage] Surface reinforcement tool doesn't work

Schlagworte:
  • Allplan 2017 surface reinforcement polygon
szotyoriadam
szotyoriad…
20.09.2017 - 11:14 *

Hello,

I would like to create a reinforced concrete wall with the area reinforcement tool, but I'm having a hard time with it...
I enter the offset (picture a1), I draw a polygon (picture a2), and after I close the polygon (or hit Esc after the diagonal was drawn) it cancels the command without any error message (picture a3).
I tried this tool in a new project, and it worked fine. I noted that the polygon is represented with only one line, the concrete cover doesn't appear.

What is the cause of the problem?

Thanks in advance!

Anhänge (3)

img
a1.JPG
Typ: image/jpeg
213-mal heruntergeladen
Größe: 240,39 KiB
img
a2.jpg
Typ: image/jpeg
161-mal heruntergeladen
Größe: 395,63 KiB
img
a3.JPG
Typ: image/jpeg
172-mal heruntergeladen
Größe: 229,42 KiB

Hilfreichste Antwort anzeigen Hilfreichste Antwort verbergen

AndrejL
AndrejL
10.09.2018 - 08:54 *

Hello,

check if your model is far from the 0,0,0, if so move it closer to 0,0,0 (can use Offset cordinates in Project settings)!

Best regards.

IBK_BG
IBK_BG
16.07.2018 - 14:03

Hello I am having the same problem, could you please tell me if you found any solution ?

Thank you in advance !

szotyoriadam
szotyoriad…
18.07.2018 - 18:09 *

Allplan support told me that it's a model error. I couldn't find any solution...

AndrejL
AndrejL
10.09.2018 - 08:54 * [Hilfreichste Antwort]

Hello,

check if your model is far from the 0,0,0, if so move it closer to 0,0,0 (can use Offset cordinates in Project settings)!

Best regards.