Hello,
Im looking for a way to change the unit(from mm to m,cm) for reinforcement bars displayed in graphic cell inside the reports. Anyway i can do this or is something impossible?
Thank you!
Hi Kostya,
This is not possible because the graphic cells is hardcoded and calculated in allplan.
There is some small option for a graphic cells but that advanced. It’s similar to the legend graphic cells for bars.
The setting are mainly belong to the tool/option with reinforcement schema setting.
Bye
Mr Judy GURAVADU
Responsable Technique Préfabrication & Ingénierie
Precast Sales & Support
Allplan France & Allplan Software Engineering
Depuis 2006
Hi Kostya,
This is not possible because the graphic cells is hardcoded and calculated in allplan.
There is some small option for a graphic cells but that advanced. It’s similar to the legend graphic cells for bars.
The setting are mainly belong to the tool/option with reinforcement schema setting.
Bye
Mr Judy GURAVADU
Responsable Technique Préfabrication & Ingénierie
Precast Sales & Support
Allplan France & Allplan Software Engineering
Depuis 2006
Hi,
Can you make and try the attached setting before calculating the report?
Hatem OZDEMIR
Architect | Allplan Trainer | BIM Manager
Website: http://www.mimcad.com
Website: http://www.bimakademi.com
e-mail: hatemozdemir[at]gmail.com
Ankara / Turkiye
LinkedIn-Profil
YouTube
