Hello. Allplan users.
During the rebar modeling process, I have a question, so I would like to hear from users. I am wondering if it is possible to place a spiral reinforcement on the curved part as shown in the figure below. If possible, please share the method. Thank you.
Hello, I am the user from Vietnam.
For this type of rebar, I can give you 2 suggestions:
+Create any 3D curve (have to create 3D curve in spiral shape), then you can convert that curve into rebar with Convert Feature
+Create 3D curve also, Place a straingth barshape as a point like below; then use the Sweep/Extrude along path
Basically, In the default functions, we can create common rebar in the available list.
Beyond of that, you have to convert from 3D line/ 3D curve or create automatically with Smartpart, Pythonpart or Allplan Visual scripting.
Hope that would be helpful for you.
Hello, I am the user from Vietnam.
For this type of rebar, I can give you 2 suggestions:
+Create any 3D curve (have to create 3D curve in spiral shape), then you can convert that curve into rebar with Convert Feature
+Create 3D curve also, Place a straingth barshape as a point like below; then use the Sweep/Extrude along path
Basically, In the default functions, we can create common rebar in the available list.
Beyond of that, you have to convert from 3D line/ 3D curve or create automatically with Smartpart, Pythonpart or Allplan Visual scripting.
Hope that would be helpful for you.
