28.09.2023 - 14:23
I would like to point out a problem that is very unpleasant if I don't notice it:
In the program, the distortion factor for the section was set to 2.
Therefore, we used associative dimensions.
The size is also good in the program. See printscreen.
However, here comes the twist, on the printed pdf plan sheet, the dimension is already 2x, as it should be in reality.
There should be a solution for this. Or an update.
I have attached the pdf plan. Where the size is 2x as big as needed.
I also attached the printscreen. Size is good here.
I use Exchange for printing.
Thanks.
Gergo Szarka
